From "Practical Lubrication for Industrial Facilities"

Storage temperatures should remain moderate at all times. The oilhouse should be located away from such possible sources of industrial contamination as coke dust, cement dust, textile mill fly, and similar forms of grit or soot. It should be kept clean at all times, with regular cleaning schedules being maintained. This applies above all to the dispensing equipment, which must never be allowed to become fouled, since this results in contamination and poor functioning.

Contamination and confusion of brands are two main risks to avoid in the handling of partially emptied containers and dispensing equipment. Thus orderliness is essential. Dispensing equipment should bear a label that matches the container from which it was filled. Labels on all equipment and containers should be kept legible at all times. Drying oils, such as linseed oil, should not be stored in the oilhouse. If they get into a lubrication system, the result, of course, is faulty lubrication and stoppage.

More information about the book "Practical Lubrication for Industrial Facilities"

Test your knowledge and prepare for ICML lubrication and oil analysis certification.

QUESTION: What type of hydraulic component is sensitive to failure by silt lock?

Get the answer.

"How do you collect grease samples from large roller bearings?"

1. If possible, isolate the bearing at its installation (put a tent around it if you have one).

2. Clean the external surface of the bearing, particularly at the split point.

3. Remove the cap.

4. Using a soft spatula or other soft, pliable utensil, gently scoop the used grease from the bearing and place it into a clean plastic container). Pay attention to collect the grease that is of concern and minimize the amount of old soap that is not a concern.

5. Close the container.

6. While you are there, go ahead and clean out the old soap from the housing.

7. Replace the cap on the bearing. Tighten. Relubricate.

Mike Johnson, Noria Corporation

Submit a question | Discuss on Message Boards