Avoid using clay-based oil dry product to clean up spills. It can cause dust and contamination risks. Instead consider using absorbent pads.

Join us for Machinery Lubrication Level I training in Vancouver, BC Canada on April 15-17.

We send $100 for each tip published. Submit your tip.

Test your knowledge and prepare for ICML lubrication and oil analysis certification.

Question: There are three types of friction. What are they?

Get the answer.

"We prefilter our wind turbine gearbox oil to ISO 17/15/12. We heat the oil with band heaters on the drum and pass it three times through a three-micron filter cart. This is very time consuming. Our post filtration sampling tests show that once in a while, we fail to meet the contamination standard with this procedure. Does anyone offer a service to filter drums of oil to this ISO contamination standard so that we can get our mechanics out of the shop and up the wind turbine towers?"

Your local distributor is in business to make a buck. I suggest making arrangements with the local agent to pre-filter and guarantee cleanliness to your standard for a fee. Keep in mind that the drum itself is very dirty, and the seams (top and bottom) release trapped particles as the drum is moved and vibrated.

A better option is to receive the drum and dedicate a small side stream filter to prefilter the oil once you have it in stores. This will cost you less in the long run, and will put you in better control of the end results.

You also mention that sometimes the filtration you conduct does not meet your specification. It would be a good idea to verify that the filter element in the filter unit is rated to perform the job you require and is changed systematically to prevent filter dumping.

Submit a question | Discuss on Message Boards